House General
Kitchen
Dishwasher
- Turn on and load
Open the water tap and press the On / Off button to turn the appliance on. Verify that the equipment is in program selection mode, then load the baskets and add the specific dishwasher detergent. Finally set and start the correct program for the type of load and the degree of dirt. - Use of the detergent
Put the washing powder or tablets combined in the detergent container, if the program includes a prewash phase, put a small amount of detergent in the container. When using multi-function tablets containing salt and rinse aid, it is not necessary to fill the salt and rinse aid containers, you need to set the water softener on the lowest level and set the rinse aid container to the lower position. - Starting a Program
- Keep the appliance door ajar
- Press the On / Off button to turn the appliance on and verify that it is in program selection mode
- press the program selection button repeatedly until the indicator light of the program you want to set starts to flash
- close the appliance door to start the program
- Opening the Door During Washing
When the door is opened while a program is running, the equipment stops. This can affect energy consumption and program duration. After closing the door, the equipment will resume from the point where it was interrupted.
Note. If the door remains open for more than 30 seconds during the drying phase, the current program ends. This does not happen if the door is opened by the AutoOpen function. Do not try to close the appliance door within 2 minutes after AutoOpen automatically opens it, as this may cause damage to the equipment.
If the door is subsequently closed for another 3 minutes, the operating mode ends. - Cancellation of the Program
Press and hold the program selection button until the equipment enters program selection mode.
Check that there is detergent in the container before starting a new program. - Term of the Program
Once the program is finished, the indicator lights up.
Press the On / Off button or wait until the appliance enters standby mode. If you open the door before the standby mode is activated, the equipment will switch itself off automatically. Then, close the water tap.